RTS-10 Time Trap opticle IR trigger
The RTS-10 is a reflect IR beam wired trigger for the DM1-100 Timer. It can be used indoors and outdoors with the DM1-100 Timer to capture time results for the time trap routines, Stopwatch and Dual Reaction drills. Includes 25 foot cable with XLR 3pin connector, can be extended up to 100 feet. Does not include stand.
The RTS-10 is connected to the DM1-100 Timer using a 3pin XLR type connector. It is connected at the MAX20 LED display input panel. To set up a capture gate time trap, you will need two small camera stands, one for the RTS-10 and the second for the included passive IR reflector. Distance between the two stands, will be reduced when outside in sunlight. Indoors the distance can be up to 20 feet, outside the distance will be not less than 4 feet. Below are links to set up for a 3 cone agility drill.
Link: RTS-10 manual
The DM1-100 Timer features a 1/100th of a second Stopwatch timer with two modes of operation. Use the RTS-10 Reflect trigger plus the Padswitch trigger plate to set up an automatic time capture routine. Use for a 3 cone agility drill that resets for each in a group of athletes, or a Dual Reaction drill that uses a random time generator, start gun tone that will capture an athletes "release reaction time" plus overall time finish.
PADSWITCH Wired pressure trigger, with XLR 3pin connector on 20 foot cable.
Use with the DM1-100 Timer Stopclock time capture routines to interface with the athlete to start the clock. Low profile plate with grip texture top for sure start. Sensitive switching for hand or foot pressure.
_____________________________________________________________________
EXTENTION TRIGGER CABLE 20 foot 3pin XLR male to female cable to extend distance between the RTS-10 Reflect Trigger and the MAX20 LED display. Use to extend distance to the Padswitch also.
______________________________________________________________________
BATTERY PACK 12 Volt, 10 Ahr AGM SLA battery pack wired with power connector, carry bag, 1 amp two stage automatic charger. Provides over 8 hours operation time for the
DM1-100 Timer System.
______________________________________________________________________
AC POWER SUPPLY 3amp switching power supply with power connector for the MAX20 LED display. Use to power the DM1-100 Timer MAX20 System in place of the battery pack.
